Thingiverse
Pawbo Corner Mounting Bracket
door IOI671701
4
Downloads
3
Likes
0
Makes
Updated: I uploaded a new version with locating holes instead of the printed pegs. The pegs broke on an install when the command strips failed, but a 3mm drill, pair of M3 countersunk screws, and some superglue fixed that. The new uploaded version has two 3mm holes instead of posts so users can choose which to use/print. Alternatively, with the holes, you could use them to locate and install M3 threaded inserts if printed on an FDM printer in PLA or PETG.
Designed for a Pawbo pet camera/interactive device, available on Amazon.
The camera, when set within reach of a cat, is batted and knocked over to get to the treats contained inside the feeder portion. If you place it on a high shelf, the cat can't get to it, but the camera and laser are effectively useless. If placed on the floor, the treats end up in a pile which is bad for multiple cats.
This allows a Pawbo to be mounted in a corner (between walls, bookcase & wall, etc), but at about 1ft off the ground. This should a
Designed for a Pawbo pet camera/interactive device, available on Amazon.
The camera, when set within reach of a cat, is batted and knocked over to get to the treats contained inside the feeder portion. If you place it on a high shelf, the cat can't get to it, but the camera and laser are effectively useless. If placed on the floor, the treats end up in a pile which is bad for multiple cats.
This allows a Pawbo to be mounted in a corner (between walls, bookcase & wall, etc), but at about 1ft off the ground. This should a
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
