Thingiverse
PAWZ applicator
by Pondopholous
10
Downloads
11
Likes
2
Makes
A simple tool to ease the often difficult task of putting PAWZ dog booties on your pet.
PAWZ are wonderful balloon-like dog booties, but can be awkward to put on your dog's feet. However, if the bootie's mouth is stretched over the narrow end of the tool, the tool and bootie can be slipped over the dog's paw, and then the bootie slipped off the tool and around the dog's leg, allowing the tool to be withdrawn.
The tools is designed for use with the red "small" size PAWZ, but it should be able to be scaled as needed provided the wall thickness is maintained.
The photos show the application steps (using my fingers to represent a paw; I'd need an extra arm to demonstrate on my dog and take the photo at the same time).
PAWZ are wonderful balloon-like dog booties, but can be awkward to put on your dog's feet. However, if the bootie's mouth is stretched over the narrow end of the tool, the tool and bootie can be slipped over the dog's paw, and then the bootie slipped off the tool and around the dog's leg, allowing the tool to be withdrawn.
The tools is designed for use with the red "small" size PAWZ, but it should be able to be scaled as needed provided the wall thickness is maintained.
The photos show the application steps (using my fingers to represent a paw; I'd need an extra arm to demonstrate on my dog and take the photo at the same time).
Pondopholous also publishes on
13 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
