pax 3 charge connector insert key

if trying to fix your pax 3 charge problem you may need the plastic part surrounding the charge connector. its almost impossible to remove it without breaking it!drill out an edge of the plastic on the charge connector(use a fine screw driver to lever out)slide the inside out (push the oven end)remove the remaining plastic from the pax internals - not a two prong metal spring that 'clips' the charge connectorremove the two metal pins and dont lose them!I used a 1mm drill to dril out the pilot holes in the parthold the part with pliers while inserting the two metal pins into the drilled holesuse a spatula heated over a flame to push flat the pin headspush the pax internals back into the metal tube (mouth piece first)line up the charge connector cut out with the connections on the internalspush the part into the window -- the edge first against the two prong of the metal springa firm push down on a hard surface and it should clip firmlytada!Print SettingsPrinter Brand:CrealityPrinter: En