Thingiverse
Pax Pamir 2nd ed insert
von baubusiukas
3
Downloads
6
Likes
1
Makes
My game blocks just would not fit in the prints I found on Thingiverse.
Made block box walls thinner, removed the separator in the center to fit my blocks.
Added spacer rings at the bottom of the coin holder to make metal coins more accessible.
Slightly modified loyalty dials holder to fit the Wakhan card box.
Gathered other STLs I used into one set.
Made block box walls thinner, removed the separator in the center to fit my blocks.
Added spacer rings at the bottom of the coin holder to make metal coins more accessible.
Slightly modified loyalty dials holder to fit the Wakhan card box.
Gathered other STLs I used into one set.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!