Thingiverse
PC Fan Controller Box 3.5"
by HowardB
1
Downloads
3
Likes
0
Makes
Very good design by Aussie_ben, thanks for sharing it!
I remixed slightly to make a fully enclosed box for my Vantec Nexus Fan Controller - I'm using it for my 40mm fans on the stepper motors, so wanted it enclosed.
Using Sketchup, I literally sliced/copied the one full side of the box, flipped the orientation and attached to the open side of the box. I moved the middle screw holes on each side by 5mm towards the back so the controller front would fit flush.
A bit of a tight fit, but it fits nonetheless. If I were to print again, I would scale up by 1%.
NOTE:
- I've included the SKP file I used.
- "Fan Controller Cover.stl" - this is the file I printed via Simplify3D using an SD Card
- "Fan_Controller_Cover_Fixed_MakePrintable.stl" - I ran the above file though Make Printable, as Cura/Sl1cer seemed to find errors. Check your preview before printing.
I remixed slightly to make a fully enclosed box for my Vantec Nexus Fan Controller - I'm using it for my 40mm fans on the stepper motors, so wanted it enclosed.
Using Sketchup, I literally sliced/copied the one full side of the box, flipped the orientation and attached to the open side of the box. I moved the middle screw holes on each side by 5mm towards the back so the controller front would fit flush.
A bit of a tight fit, but it fits nonetheless. If I were to print again, I would scale up by 1%.
NOTE:
- I've included the SKP file I used.
- "Fan Controller Cover.stl" - this is the file I printed via Simplify3D using an SD Card
- "Fan_Controller_Cover_Fixed_MakePrintable.stl" - I ran the above file though Make Printable, as Cura/Sl1cer seemed to find errors. Check your preview before printing.
HowardB also publishes on
6 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
