Thingiverse
Learning
Go to Model
PC Fan Windmill
96
Downloads
80
Likes
0
Makes
Build video and commentary:
https://www.youtube.com/watch?v=BPO6Zh8VWvo
My channel:
https://www.youtube.com/channel/UCQ9qxInZTJznj3O18qymalQ
This little windmill body is made to fit most standard-size PC fans. It's a great upcycling project, and should work with little effort.
You will need a 5/16 bolt or threaded rod, two-to-four 5/16 nuts, and two 608-2RS bearings. Printing at low layer heights is recommended because it makes the bearing holes easier to fit the bearings into. I recommend printing face-down if your print area is large enough. Good luck! Check out my YouTube channel!
https://www.youtube.com/watch?v=BPO6Zh8VWvo
My channel:
https://www.youtube.com/channel/UCQ9qxInZTJznj3O18qymalQ
This little windmill body is made to fit most standard-size PC fans. It's a great upcycling project, and should work with little effort.
You will need a 5/16 bolt or threaded rod, two-to-four 5/16 nuts, and two 608-2RS bearings. Printing at low layer heights is recommended because it makes the bearing holes easier to fit the bearings into. I recommend printing face-down if your print area is large enough. Good luck! Check out my YouTube channel!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
