PC Table microphone with 6mm capsule

On-table simple supportless PC microphone in 4 parts.

Electrical parts required:
- 6mm electret microphone capsule (from headphones or webcam etc.)
- 10-150 cm length twin wire + 3.5mm jack plug

Materials required:
- Generic PLA plastic
- Generic glue for glueing up parts
- Solder wire

Tools required:
- Generic 3D printer
- Electrical solder iron

Assembly order:
0. Snap off the frame from its base (only used for printing)
1. Pass free end of wire into little hole in the frame and through microphone head. Make a knot after frame and put it inside.
2. Solder up wire to microphone capsule
3. Place the capsule inside head and put a cap onto it
4. Tie all parts (base, frame and head+cap) using glue.