Thingiverse
PC Universal Backplate IOShield
von 3DWannaBe
452
Downloads
538
Likes
9
Makes
It's a grid inlay inside an IOShield. Simply cut away the areas where your ports are to make a custom backplate.
Instructions:
1 - Pop it into your motherboard backplate area.
2 - Align your motherboard with screw holes inside case.
3 - Mark out your port areas on grid shield.
4 - Remove from case.
5 - With an Exacto knife or sharp blade on a flat surface cut out the grid areas to expose your ports.
6 - put it back into your case and repeat until happy.
Alternatively, you can use it as a template to cut a plain IO Shield but I'm personally happy with the results of this.
I've personally misplaced a number of IO shields that this is a happy replacement and Im not talented enough to measure and recreate an IO shield so this really works for me.
Instructions:
1 - Pop it into your motherboard backplate area.
2 - Align your motherboard with screw holes inside case.
3 - Mark out your port areas on grid shield.
4 - Remove from case.
5 - With an Exacto knife or sharp blade on a flat surface cut out the grid areas to expose your ports.
6 - put it back into your case and repeat until happy.
Alternatively, you can use it as a template to cut a plain IO Shield but I'm personally happy with the results of this.
I've personally misplaced a number of IO shields that this is a happy replacement and Im not talented enough to measure and recreate an IO shield so this really works for me.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
