Thingiverse
PC4-M10 Filament Filter
por Foppemoa
29
Descargas
16
Likes
0
Makes
A filament filter that snaps on to a PTFE tube, using a PC4-M10 coupler.
Put a small piece of foam inside of it and ram a pointy piece of filament through the entire filter several times.
This is to form a hole and remove any chunks of foam that you ripped out with the filament.
For easier insertion you might want to chamfer the end of the PTFE tube.
Put a small piece of foam inside of it and ram a pointy piece of filament through the entire filter several times.
This is to form a hole and remove any chunks of foam that you ripped out with the filament.
For easier insertion you might want to chamfer the end of the PTFE tube.
Foppemoa también publica en
85 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
