Thingiverse
PCB clamp
von Karlosek
60
Downloads
39
Likes
0
Makes
My take on this simple PCB vice.
I had a piece of 10 mm aluminium pipe laying around so I used it for guiding rods.
The end pieces should be of tight fit but I had to use few drops of superglue.
Jaws are pulled together with rubber band, secured in place with a piece of filament.
I had a piece of 10 mm aluminium pipe laying around so I used it for guiding rods.
The end pieces should be of tight fit but I had to use few drops of superglue.
Jaws are pulled together with rubber band, secured in place with a piece of filament.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
