Thingiverse
PCB clip holder
von necro133
21
Downloads
12
Likes
0
Makes
Hi.
This is my another project. I've made that to my friends from work just to make their job easier.
Print one of each part. You will need M5x20mm bolt, nut and washers also, 3 springs with
a diameter of 7mm and length of about 10mm.
Assembly just like on photos ;)
Cheers
This is my another project. I've made that to my friends from work just to make their job easier.
Print one of each part. You will need M5x20mm bolt, nut and washers also, 3 springs with
a diameter of 7mm and length of about 10mm.
Assembly just like on photos ;)
Cheers
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
