Thingiverse
PCB double clamp
von PalmyreSG1
18
Downloads
14
Likes
0
Makes
I designed this thing to hold the PCB and its martyrdom on the CNC table to make a double sided.
The board should be 10mm thick and about 25mm wider than the PCB.
The additional parts needed for 4 things are:
- 4 M6 or M5 x20mm screws
- 4 M6 or M5 T-nuts
- 4 M4 x25mm screws
- 4 M4 heat install brass inserts
The board should be 10mm thick and about 25mm wider than the PCB.
The additional parts needed for 4 things are:
- 4 M6 or M5 x20mm screws
- 4 M6 or M5 T-nuts
- 4 M4 x25mm screws
- 4 M4 heat install brass inserts
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
