Thingiverse
PCB Drill Press Modifications
von jhitesma
13
Downloads
10
Likes
0
Makes
My modifications to Mape's PCB Drill press.
1) The 8mm smooth rods I found were 100mm long (and actually measured 103mm) so I made the frame a bit taller.
2) I added 608 on the axle so the threads don't turn against plastic.
3) I tightened the holes for the smooth rods - I'd rather they be a tight fit than have any slop.
4) I added holes and nut traps for 2 M3 screws at the front of the lid to clamp the the smooth rods in place - with the tighter fit this helps pull it together.
5) I added a clip to hold my chuck key on the side.
6) I redrew the lever handle and attachment so they have printed threads and the M8 all thread just screws in place.
7) I drew a printable base - but then just used it as a pattern to make one from wood with some printed feet. I've included a PDF of the pattern.
1) The 8mm smooth rods I found were 100mm long (and actually measured 103mm) so I made the frame a bit taller.
2) I added 608 on the axle so the threads don't turn against plastic.
3) I tightened the holes for the smooth rods - I'd rather they be a tight fit than have any slop.
4) I added holes and nut traps for 2 M3 screws at the front of the lid to clamp the the smooth rods in place - with the tighter fit this helps pull it together.
5) I added a clip to hold my chuck key on the side.
6) I redrew the lever handle and attachment so they have printed threads and the M8 all thread just screws in place.
7) I drew a printable base - but then just used it as a pattern to make one from wood with some printed feet. I've included a PDF of the pattern.
jhitesma veröffentlicht auch auf
21 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!