Thingiverse
PCB Holder pin
von kinneko
17
Downloads
16
Likes
0
Makes
PCB Holder pin
Other required parts:
- Neodymium magnet 6x3mm
- Tapping screw M2 6mm
- Spring 0.6 x 7.4 x 11 mm
The spring is obtained by disassembling a cord stopper for handicraft.
If necessary, make an anti-slip material on the bottom.
Other required parts:
- Neodymium magnet 6x3mm
- Tapping screw M2 6mm
- Spring 0.6 x 7.4 x 11 mm
The spring is obtained by disassembling a cord stopper for handicraft.
If necessary, make an anti-slip material on the bottom.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
