Thingiverse
PCB rotating stand
door 3Rotor
333
Downloads
275
Likes
5
Makes
An 4 part stand that only needs the addition of 2 M8 Bolts/nuts and a little spring with some washers, Provision is made for a locking screw( M6) if it's needed.
This stand is to Hold a circuit board while components are being soldered in, facilitating easy rotation to get access to both sides of the board for soldering.
rubber feet can be attached to the bottom, to give is more sturdiness in its stand.(not required)
This device complies with Einstein's general simplicity principles, in that it is as simple as it possibly can be, but no simpler... :~)
This stand is to Hold a circuit board while components are being soldered in, facilitating easy rotation to get access to both sides of the board for soldering.
rubber feet can be attached to the bottom, to give is more sturdiness in its stand.(not required)
This device complies with Einstein's general simplicity principles, in that it is as simple as it possibly can be, but no simpler... :~)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
