PCB Vise

Just an over built PCB holder. It will hold a PCB with a depth of 52mm.

Only the rear jaw and front jaw need supports. The shaft will need a brim for safer printing.

I printed mine at .12mm for a nicer finish.

The spring I used has an ID of 16mm and a length of 72mm. If it helps, I bought the spring as ACE Hardware here in the states.

You will need to epoxy the front jaw to the shaft. 5 Minute works great!

Parts needed:

Spring - ID of 16mm and length of 72mm
M3 Bolt - 24mm
M3 Nut - 2