Peak Design Compatible Camera Clip / Anchor

This clip is an exercise in designing parts for specific process of manufacturing and you probably should not blindly trust it with your expensive camera!

! WEIGHT TEST BEFORE USE ! USE AT YOUR OWN RISK !

BUILD STEPS:
* 1 - PRINT : 100% Fill and high nozzle temp
* 2 - POST-PROCESS : Clean up the bottom faces and drill out the hole with 1.2MM drill
* 3 - ATTACH THE LANYARD : Fill the Pocket with JB-Weld (or other 5min resin) . Insert the the chord (if you are not using a loop MELT THE ENDS TOGETHER!) than insert 1mm steel pin (wire) through the Small hole
* 4 - Clean any squeeze-out resin and let it fully cure for 24 hr