Peak Design Mobile Wall Mount

This is a wall mount for the Peak Design mobile phone cases.

You'll need 4 Harbor Freight Rare Earth Magnets that are .8cm(5/16") in diameter. They are sold in capsules that hold 10 magnets.

Double check to make sure you get the polarity correct for your phone so that the magnets are facing the correct direction, then glue them in place. I used some cyanoacrylate(superglue) as well as JB Weld and both work fine. If you mess up the direction of the polarity, I designed it so that you can pop the magnets out using the holes that pass through the model. The holes also act as a channel for the excess glue as well when pressing in the magnets.

As a finishing touch, I glued some fabric to the face of the wall mount to prevent the magnets from popping out and also to be a soft interface to the phone case.

To attach the mount to the wall, I just used some command strips so that they can easily be removed in the future.