Pebble Time Round Charging Stand

Fairly straight forward vertical stand for the Pebble Time Round, designed to allow the straps to hang downwards instead of requiring you to feed them through gaps as required in other designs. This is a quick 15 minute design I did, I may update it and refine the design once I've decided to definitely keep my PTR over my PTS, but I may just leave it too - it works as is.

The charging cable is secured into the printed part with a small strip of 3M 03609 VHB tape. The wire snakes around behind the side flange, and is also held in place with a few strips of the same VHB. Most auto parts stores carry this tape for trim bonding. This design must be held down with a Command Adhesive strip between the bottom of the stand and the surface top; the weight of the stand is not sufficient to allow you to just pull the watch off and the base is small enough it's liable to tip over.

Printed on an UM2 with 0.2mm layer heights at 40 mm/s, 50% infill for structural rigidity. No support needed.