Pedal Door Stopper

This is a small, easy to use, and works well. When a door is pushed into the door stop, the pedal in the back is move, releasing the pedal to hold the door in place. To close the door, step down on the pedal. When the pedal is pushed down it latches in place, and the door is free to shut. The TPU does not hold the door in place the best, but you can use double sided tape or even an adhesive to hold the door stop in place. In order for the door stop to fit, the door must have a gap of at least for 7mm under the door. Non-3D printed materials:You will need 2 loom bands from a rainbow loom kit, or very mall rubber bands around 1.5cm in diameter.You will also need the small spring from a mechanical pencil. I used a spring from a papermate mechanical pencil. This door stop could break under a very heavy load. If there is a strong spring that pulls hard on the door, I would suggest not using this door stop. The door stop should work with doors that have light springs or no springs at all. Th