Pedalboard ends

I was inspired by other pedalboard ends I saw but wanted something with a flat bottom so I could stick pads on the bottom to keep it fro sliding around. This is designed to use the 1/2” x 2-1/2” poplar boards you can by at Home Depot. The fit should be tight enough to hold on it’s own but there are screw holes just in case.
I’ve created ends to use 2 and 3 boards. There is a choice between straight or rounded edges as well as an option for the 3 board end with 24mm holes for panel mounted jacks. You may have to file a bit to get particular jacks mounted as well as drill holes for the bolts.
I only created the left side but you can easily mirror the right side in Cura.