Pedestrian Traffic Light - Ampel

Description Pedestrian Traffic Light Quick and easy to build - snap fit - no screws needed Final dimension assembled: 4x4x15cm (LxWxH) Print No support Orientation as in the files Infill 15% Material: PLA Parts needed 1x WS2812 / Neopixel stick (or similar e.g. https://www.roboter-bausatz.de/p/8bit-rgb-led-leiste-aehnl.-neopixel Jumper cable ≥ 20cm e.g. https://www.roboter-bausatz.de/p/40-pin-dupont-jumper-kabel-buchse-stecker-40-cm Microcontroller (Raspberry, ESP32, Arduino , Calliope,…) Cut Cut 2 pixel from the stick to make it fit into the housing. (see pictures) Solder Cut the jumper cable on one side and solder it to the LED stick (GND, 5V, DIN) Assemble Insert the stick Fix the stick by using the spacer Push the cable including connector through the standpipe Connect the stand pipe Connect & Code Calliope: LED Stick 5V → Calliope + LED Stick GND → Calliope - LED Stick DIN → Calliope P0 Arduino: LED Stick 5V → Arduino 5V LED Stick GND → Arduino GND LED Stick DIN → Arduino D6 ESP32