Peg Board wire holder

Holds spools of wire to a pegboard.

Prints best with supports

### Wooden dowels:
I use barbecue skewers or chopsticks. Any stick smaller than 5/16 inch (9mm) diameter should work.

### Pegboard attachment points:
For most strength, print with the 'side' down.

### Fusion 360 Files

https://a360.co/2tFxpZV


Based on the pegboard holders from "Make Anything's" [youtube video](https://www.youtube.com/watch?v=-eGW-VmvHYE&t=148s)

## Spools

Confirmed working with these spools

https://a.co/d/hsNHrNj
https://a.co/d/4NyI6u7