Slicer Discord
Pegboard Digital Micrometer Hook – Modello 3D stampabile da Thingiverse Thingiverse

Pegboard Digital Micrometer Hook

di renrip
18 Download
7 Likes
0 Makes
Vai al Modello
A pegboard hanger for digital micrometers.

I think that all theses have close to the same dimensions so it should work well for you.
I've pictured it holding my Neiko and a cheapie from amazon. Both hang straight.

The hooks have about 33mm of space inbetween and the hooks are offset vertically by 15mm.

The holes for the hooks were a little loose in the one I printed and I did have to glue them in.
I tightened up the hole tolerance and it should be better.
Worst case, they're a little too tight and you may have to file just a little.

No supports are needed but you must rotate the base to lay flat.

Also, I found that upping the wall count to 3 makes the hooks stronger but I'm sure that standard 0.2mm settings will work.

Print the base STL and 2 of the hook STL.

I used a small (4mm) brim but I always do to prevent corners from pulling off of the print bed.
Fonte
Thingiverse
Cosa serve per stampare: Principiante Bassa affidabilità
Perché?
senza supporti
Senza supporti Pezzo unico
Supporti 0/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 1/3
Stampante
FDM / FFF
Formato file
STL
Materiale
Post-elaborazione
Incollaggio
Software
Cura, PrusaSlicer o simile
Stesso designer, più piattaforme

renrip pubblica anche su

19 modelli aggiuntivi su altre 1 piattaforme

Verificato dalla corrispondenza dei titoli dei modelli tra le piattaforme.
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione