Thingiverse
Pegboard hammer holder
von shaune23
103
Downloads
55
Likes
0
Makes
This is a remix of some of mother-of-crafts-3d's work. For my pegboard the pegs were too short to stay in the pegboard so I mashed it up with _____.
Hopefully this rounds out your collection for the peg board.
FYI I printed all of these on their side. If I print them upright, the pieces break between the layers.
Hopefully this rounds out your collection for the peg board.
FYI I printed all of these on their side. If I print them upright, the pieces break between the layers.
shaune23 veröffentlicht auch auf
2 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
