Thingiverse
Pegboard Pin-punch Holder
di rharding13
101
Download
63
Likes
0
Makes
A pegboard holder for a set of brass pin-punches.
I have attached four versions:
* With, and without the sizes printed on it, in case your selection of sizes is different from mine.
* With the punches straight up/down, or tilted outwards at a 10 degree angle. Tilting them outwards makes the punches easier to access if there's something else above them on the pegboard.
Mounts on 1/4" pegboard using my [lockable pegboard rivets](https://www.thingiverse.com/thing:4665791).
I have attached four versions:
* With, and without the sizes printed on it, in case your selection of sizes is different from mine.
* With the punches straight up/down, or tilted outwards at a 10 degree angle. Tilting them outwards makes the punches easier to access if there's something else above them on the pegboard.
Mounts on 1/4" pegboard using my [lockable pegboard rivets](https://www.thingiverse.com/thing:4665791).
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
