Thingiverse
Pegboard Pin
von rfiorenza80
15
Downloads
8
Likes
0
Makes
I built this pin in order to use a standard Home Mini mount on peg board. The home mini mount I was using is this one:
https://www.thingiverse.com/thing:2599534
I then drilled out the inner hole to account for the pin which is 5.75mm in order to fit snugly in the pegboard.
https://www.thingiverse.com/thing:2599534
I then drilled out the inner hole to account for the pin which is 5.75mm in order to fit snugly in the pegboard.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
