Pegboard Wii Remote Holder

Get those Wiimotes off the ground and in their place. The great "wiimote holder by roseman" is the business end of this thing, with a custom-made slider connecting it to a pegboard piece, courtesy of "Pegstr-Pegboard Wizard by mgx."

Wiimote holder - https://www.thingiverse.com/thing:1354303
Pegstr - https://www.thingiverse.com/thing:537516

The pegboard side prints as-is, and I don't use supports. Per the Pegstr instructions, print with 4 top/bottom layers and you can just trim off the loose overhang from the upper pegs.

I don't use support on the Wiimote holder, but you can if you like. I just trim off the loose overhang as the back side is never seen.

The tolerance on the fit is pretty tight, so you may need to sand/file the interlocking parts just a bit before using.

You'll need to fit the pegboard piece, then slide in the Wiimote holder on, as you cannot attach it to the board as one-piece. See photos.

The pegboard half is interchangeable with Pegboard Xbox Contro