Thingiverse
Pegboard Wire Anchor
di Boogiemann
26
Download
13
Likes
0
Makes
This anchor was created to hang some decorative lights on my pegboard. This is a lightweight anchor and is not intended for holding extension cords.
This is quite small, so unless you print with 1 wall, it will end up to be 100% filled. I printed with PLA but don't see why ABS or any other materials might not work.
Once printed, simply tug the wire into the slot and snap into the pegboard.
This is quite small, so unless you print with 1 wall, it will end up to be 100% filled. I printed with PLA but don't see why ABS or any other materials might not work.
Once printed, simply tug the wire into the slot and snap into the pegboard.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
