Pegboard Wire Management

I have a power cord that is basically permanently plugged into an outlet at my workbench, but the cable is hanging loose on the workbench and in the way. So I designed this and printed a few to keep the power cord out of the way.

When I printed this, I used the support as shown in the picture. When I sliced this, I didn't realize the support Z-height was too low by a fraction. It pushed the model 1 layer up, so my 1st layer was just the support and skirt, but it still printed fine.
You don't need a lot of infill, but I think I used at least 10% cubic with 100% on the pegs.
I always print with 4 walls for strength.

You should be able to use tree supports as well or whatever your favorite style is. It is not a complicated piece to print, so play around with your settings.