Thingiverse
Pegged bathroom hook
von niteria
1
Downloads
0
Likes
0
Makes
A little clip-on hook that pegs into the side of one of my shelves.
It printed just fine with 0.2 layer height and 20% infill. I added support because of the pegs. I needed to rotate it upright in Slic3r, I'm a n00b, so I can't do it in CAD.
It printed just fine with 0.2 layer height and 20% infill. I added support because of the pegs. I needed to rotate it upright in Slic3r, I'm a n00b, so I can't do it in CAD.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!