Peggit - Pegboard Mounting System

IntroductionThe Peggit system is a simple way to attach holders and organizers to your pegboard using simple automotive rivets. The clip easily attaches to standard pegboard with 1" spacing using 15mm x 12mm x 6mm automotive push rivets. Holders can be easily removed from the clip by pressing the two arms on the bottom of the clip, making it easy to move your holders around.Available ModelsThis model is just for the clip, you will need holders to attach to the clips. View the whole Peggit Collection.10" Magnetic Screwdriver Holder5" Magnetic Screwdriver Holder12" Magnetic Screwdriver HolderSmall Magnetic Bit HolderMagnetic Extension HolderPrintingThe clip prints flat at 0.2mm layer height without supports. PLA is just fine for this application since there's very little stress on the part and the arms aren't under tension once clicked in place.Tips and TricksIf you're testing out an arrangement of holders, you can install the rivets, but remove the center pin