Pellet Can Wall Holder

I designed this to hold my large pellet cans on the wall like JSB's & Air Arms' (smaller pellets cans fit as well, but not as snuggly). I used double stick mounting tape, but I made the cut outs so that one can hang it with a couple of nails or such (plus, it saves a little time and filament).

Watch your support settings, because you want them easy to remove. Even with 1% support density and it was difficult for me to remove. I significantly lowered the roof and floor support density and it was a bit easier.

There is a single and a stacked double holder. I wanted to do 4 up, but I would need a bigger bed and new 3d printer. Where are the financially blessed beautiful people out there? Jk

Last note, I used PLA Pro with 20% infill. It is strong enough for me, but you may want it with a bit more infill.