Pen Guide for Cutting Module V2

The Bambu Pen Holder has a lot of play in the X direction, which causes lines drawn by a pen to be offset right or left from their true position. This Pen Guide is a simple solution to reduce pen ‘wobble’. Pen wobble is discussed more here:https://forum.bambulab.com/t/pen-module-wobbling/193244Boost MeIf you find this useful, please give me a boost.If you print it, please leave a comment that lets me know if it worked for you or not. Feedback will help me make it better. Thanks! The Pen Guide slips onto the Cutting Module from the bottom, then the Pen Holder is pressed up into the Cutting Module and through the Pen Guide from the bottom. Now the Cutting Module is slid down onto the Toolhead and clamped. The figure below shows the Pen Guide properly positioned.The Pen Guide rests on a box that is part of the Toolhead, which determines its vertical position. After the Cutting Module is installed on the Toolhead, adjust the Pen Guide so that it is level. During calibration the extruder co