MakerWorld
Office
Go to Model
Pen Holder
14
Downloads
11
Likes
4
Makes
I basically wanted a pen holder to make the pen on my desk look more astetic so I did just that. The pen itself is is about 10.8mm in diameter and i designed the holder with some wiggle room so it can hold the pen nicely with it getting stuck when trying to pull it out. I recommend printing it with a higher infill so that it stays in its place and so when you try to pick up the pen, it wont move the holder. Enjoy!!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
