Thingiverse
Pen holder
von One_Ying
8
Downloads
9
Likes
0
Makes
This is a design of pen holder for delta 3d printers.
Make sure to make it 10 times larger before you start to print.
The springs I used is took from pilot g2 pens.
m3x16 screws and m3 nuts are needed to assemble it up.
I am too lazy to write everything. Let me know if you have any questions.
Have fun.
https://www.youtube.com/watch?v=b2kaDUD-TWg
Make sure to make it 10 times larger before you start to print.
The springs I used is took from pilot g2 pens.
m3x16 screws and m3 nuts are needed to assemble it up.
I am too lazy to write everything. Let me know if you have any questions.
Have fun.
https://www.youtube.com/watch?v=b2kaDUD-TWg
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
