Pen Stand 02

Simple vertical pen holder. Center hole is about 0.5"; big enough for typical pens, but capped pens with pocket clips won't fit. We'll do another version that's approximately the same but includes a slot for capped pens.

Printing on an FDM printer will likely require a bit of post-processing, but should be relatively minor. On an SLA it's quite nice (e.g., Form 2). Current image is an FDM without any sanding; whiskers are likely. Print with supports if your printer has issues as the centered cylinder is basically unsupported. Image is of a print without supports on a MakerGear M3.

This is available in a variety of materials on Shapeways as well; the last picture is a steel print.

* https://www.shapeways.com/product/447BLMM68/pen-holder-02