Thingiverse
Pen Stem for flat flower Daisy
door mgcarguy
5
Downloads
12
Likes
0
Makes
created a stem that a BIC Pen insert could be sliped into so you can write with the flower and refill as needed.
The petals and center can be found on the original posting
www.thingiverse.com/thing:2182466
A little support is needed under the ends that insert into the flower petals.
May need to sink it a little under the plate if you do not have good adhesion
I used a heat gun to bend the end so the flower was facing forward not upwards and shape the leaves after it was assembled.
The petals and center can be found on the original posting
www.thingiverse.com/thing:2182466
A little support is needed under the ends that insert into the flower petals.
May need to sink it a little under the plate if you do not have good adhesion
I used a heat gun to bend the end so the flower was facing forward not upwards and shape the leaves after it was assembled.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
