Thingiverse
Toys & Games
Go to Model
Pencil Fidget Ring
377
Downloads
391
Likes
2
Makes
I thought it would be handy to have a fidget on a pencil. This is designed for a standard, #2 pencil.
Supports are required but are very easy to remove. The support will usually only be on the ring and nearly comes off on it's own when you remove it from the build plate.
If it is difficult to install, slide it on from the sharpened end of the pencil, not the eraser end. Also, twist the pencil in the same direction as the small ribs inside of the fidget.
Please post your makes and comments.
Supports are required but are very easy to remove. The support will usually only be on the ring and nearly comes off on it's own when you remove it from the build plate.
If it is difficult to install, slide it on from the sharpened end of the pencil, not the eraser end. Also, twist the pencil in the same direction as the small ribs inside of the fidget.
Please post your makes and comments.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
