Thingiverse
Pencil Holder - Wall or Stand type
von Tori68
118
Downloads
91
Likes
0
Makes
This is a pencil holder with 12 holes(14mm Dia.)
I printed only wall mounted type. (stand type not tested, but will be also good)
No supporter required.
I used tacks to hold onto the wall.
Thanks!
* Recently, I found the hook of wall type is weak. so, I replaced it new file, PencilH_wall2.stl
I printed only wall mounted type. (stand type not tested, but will be also good)
No supporter required.
I used tacks to hold onto the wall.
Thanks!
* Recently, I found the hook of wall type is weak. so, I replaced it new file, PencilH_wall2.stl
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
