Thingiverse
Penny Fidget Spinner
von 1Eye
25
Downloads
12
Likes
0
Makes
Yet another fidget spinner. This on based on the suggestions and process from Joel, AKA the "3D Printing Nerd" as found here: https://www.youtube.com/watch?v=EgOuvOLiwAM
The fit is very snug so the pennies won't fall out. I had to use a bit of force to get the pennies in. It may be just my printer (calibration prints measured to be about .1-.5% over size) but you may need to up-scale a few percent for easy assembly.
The caps are "monogrammed" but I have also uploaded blank ones if you don't share the initial.
Print, smash in a bearing, 15 pennies, and the caps. Enjoy!
(Drop me a note for the Fusion360 files if you want them)
Update: Printed one out in Ninjaflex for fun. Much more durable but the pennies need to be glued in place...
The fit is very snug so the pennies won't fall out. I had to use a bit of force to get the pennies in. It may be just my printer (calibration prints measured to be about .1-.5% over size) but you may need to up-scale a few percent for easy assembly.
The caps are "monogrammed" but I have also uploaded blank ones if you don't share the initial.
Print, smash in a bearing, 15 pennies, and the caps. Enjoy!
(Drop me a note for the Fusion360 files if you want them)
Update: Printed one out in Ninjaflex for fun. Much more durable but the pennies need to be glued in place...
1Eye veröffentlicht auch auf
11 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
