Thingiverse
Penta collet
von freeagents
0
Downloads
0
Likes
0
Makes
Penta collets for building fly fishing rods in various sizes.
3/16", 7/32", 1/4", 9/32", 5/16", 11/32", 3/8", 7/16", 1/2"
I printed these on a Creality Ender V3SE with the following settings in Cura. The gyroid infill was critical in making it strong enough for use. Have tested with PLA and PETG, both work but would suggest using PETG.
Super Quality (0.12 mm layer height)
Wall Line Count 4
Infill 20% Gyroid
Support everywhere
3/16", 7/32", 1/4", 9/32", 5/16", 11/32", 3/8", 7/16", 1/2"
I printed these on a Creality Ender V3SE with the following settings in Cura. The gyroid infill was critical in making it strong enough for use. Have tested with PLA and PETG, both work but would suggest using PETG.
Super Quality (0.12 mm layer height)
Wall Line Count 4
Infill 20% Gyroid
Support everywhere
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!