Thingiverse
Pentagram Vase
von JobSmolders
57
Downloads
44
Likes
0
Makes
Pentagram Vase
This Model is actually an old one made into a solid for spiral vase mode.
I used it to test my big printer for the first time.
The Blue one is 700mm high and printed in ABS 240°C, nozzle 0.5mm and resolution 0.35mm.
Unfortunately, it deformed due to warping. But that was to expect due the fact that printer is a open construction and printing time was like 24 hours :-)
The translucent PET-G one is super stretched and printed with the same setup as above but at 220°C and at 0.25mm resolution. That one is 520mm high.
This Model is actually an old one made into a solid for spiral vase mode.
I used it to test my big printer for the first time.
The Blue one is 700mm high and printed in ABS 240°C, nozzle 0.5mm and resolution 0.35mm.
Unfortunately, it deformed due to warping. But that was to expect due the fact that printer is a open construction and printing time was like 24 hours :-)
The translucent PET-G one is super stretched and printed with the same setup as above but at 220°C and at 0.25mm resolution. That one is 520mm high.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
