Thingiverse
Household
Model downloaden
PentaPot
652
Downloads
472
Likes
2
Makes
With this pot and the plate you will have an ideal place for your plants.
At the bottom I added a small hole where the water could flow though if you gave too much. This is ideal for my Lithops which don't need so much water. There are coming from Africa and there the rain very rare..
From autumn to spring you shouldn't them water at all. From spring to autumn I am giving them 4-6 times water in 6 month.
You don't need supports and not a lot of infill. I used 15%. It depends on your taste which layer height you are using. I used a 0.5mm nozzle with a layer height of 0.3mm.
At the bottom I added a small hole where the water could flow though if you gave too much. This is ideal for my Lithops which don't need so much water. There are coming from Africa and there the rain very rare..
From autumn to spring you shouldn't them water at all. From spring to autumn I am giving them 4-6 times water in 6 month.
You don't need supports and not a lot of infill. I used 15%. It depends on your taste which layer height you are using. I used a 0.5mm nozzle with a layer height of 0.3mm.
XoGuSi publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
