Thingiverse
Peon230 Antenna Mount
por rage1618
2
Descargas
2
Likes
0
Makes
This is an antenna mount for the Peon230 3D printed quadcopter.
I needed something to support the two antennas of my FrSky reciever at 90 degrees to each other.
The mount slots in to 3 slots near the quadcopter "logo" on the top plate and is secured by zip-ties.
The two circular holes are designed to fit a 3mm straw to support the antennas or you can secure the antennas to the zip-ties.
The larger hole in the middle was intended to allow an FPV antenna to come up through the support but I have not finished this feature yet.
I needed something to support the two antennas of my FrSky reciever at 90 degrees to each other.
The mount slots in to 3 slots near the quadcopter "logo" on the top plate and is secured by zip-ties.
The two circular holes are designed to fit a 3mm straw to support the antennas or you can secure the antennas to the zip-ties.
The larger hole in the middle was intended to allow an FPV antenna to come up through the support but I have not finished this feature yet.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!