Thingiverse
Persian (Cat)
von Print8Paint3D
9
Downloads
5
Likes
0
Makes
#053 Persian
I designed this model so that you can print it without support.
Also uploaded the same model without the red point on the head, so you can use it as a "normal" cat.
!!! Don't forget to print the walls inside out!
Before both sides of the tail connect, i pressed the warm filament down slightly with the spatula. (minute 0:46 in the video)
https://www.youtube.com/watch?v=HyFEohixKIo&list=PL1OsNQIDlo4uQpxiUHadn-uWuHNYxWLdQ&index=21
I designed this model so that you can print it without support.
Also uploaded the same model without the red point on the head, so you can use it as a "normal" cat.
!!! Don't forget to print the walls inside out!
Before both sides of the tail connect, i pressed the warm filament down slightly with the spatula. (minute 0:46 in the video)
https://www.youtube.com/watch?v=HyFEohixKIo&list=PL1OsNQIDlo4uQpxiUHadn-uWuHNYxWLdQ&index=21
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
