Personal Sprouter

Personal-size sprouter for those who cannot use mist nozzles hooked to a water timer. This type trickles water and drains into a sink. If you have access to a laundry hook-up then do the mist nozzle version instead, as seen on youtube at ...v=OY2Ezu5GYMo and ...v=C0ShRKftcOk (sorry I didn't post the entire URL but thingiverse puts it into the files if you do that and these are not part of this project).

NOTES:
- For a complete working sprouter you need to add a water bucket, small submersible pump, electric timer and a strip of green pot-scrubber cut to fit into the drain slot.
- Or as an alternative you can use a water timer and water bucket positioned higher than the sprouter in order to gravity feed the water.
- Print the "lid" in something transparent enough for the sprouts to get some light and turn green (I'm using natural PLA)
- Print the "cap" in something like ninjaflex (if possible) so it will form a good seal.
- The cap and flow restrictor are based on 1/4" ID, 3/8