Thingiverse
PET Bottle Carrier
von FuzzytheBarnes
0
Downloads
6
Likes
0
Makes
Why?
Do you have to lug around a six-pack of 1.5-liter PET bottles?
New and filled?
The ones in the thin, easily tearable foil packaging?
The ones that fall apart 20 meters from the store?
Use this bottle carrier!
PLA, PETG, ABS, and all other "normal" filaments are suitable. TPU, understandably, is not.
Please note that there are two different 1.5-liter PET bottles in circulation in Germany, divided into A and B models. They can be distinguished by the bottle neck, as shown in the image.
Procedure:
First, print test piece A and test piece B and check which fits better. Then select the appropriate bottle carrier and optionally the upgrade barrier, which must be printed twice. This works with both A and B models.
50% infill is strongly recommended, as it has to lift 9 kg.
DO NOT use Organic Support. If it breaks at the bottom, the Handle will be a mess and a pain to touch.
Every Part comes in two file versions: 3MF and STL, depending on your preference.
With a Prusa MK3s, you'll
Do you have to lug around a six-pack of 1.5-liter PET bottles?
New and filled?
The ones in the thin, easily tearable foil packaging?
The ones that fall apart 20 meters from the store?
Use this bottle carrier!
PLA, PETG, ABS, and all other "normal" filaments are suitable. TPU, understandably, is not.
Please note that there are two different 1.5-liter PET bottles in circulation in Germany, divided into A and B models. They can be distinguished by the bottle neck, as shown in the image.
Procedure:
First, print test piece A and test piece B and check which fits better. Then select the appropriate bottle carrier and optionally the upgrade barrier, which must be printed twice. This works with both A and B models.
50% infill is strongly recommended, as it has to lift 9 kg.
DO NOT use Organic Support. If it breaks at the bottom, the Handle will be a mess and a pain to touch.
Every Part comes in two file versions: 3MF and STL, depending on your preference.
With a Prusa MK3s, you'll
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
