Thingiverse
PET Bottle Opener (minimum model)
door asimomagic
374
Downloads
266
Likes
2
Makes
I've made a number of PET bottle openers so far, but the thin portable model has the problem of being a little painful. I have been searching for a shape suitable for thinness, now I will introduce it because I am satisfied with it.
[Requirements]
-Small and thin to carry
-Less likely to cause pain in the hands
-Being able to distinguish between the front and back
[Design points]
-Smooth round shape
-Two small bulges facing each other
-A bank slightly higher than the fins on the back ... In the photo, the high part is printed with red filament to further clarify the difference between the front and back.
-[print conditions]
-printing type: FDM
-printer: Original Prusa i3 MKS
-filament: PETG
-support: no
-brim: no
-raft: doesn't matter
[Requirements]
-Small and thin to carry
-Less likely to cause pain in the hands
-Being able to distinguish between the front and back
[Design points]
-Smooth round shape
-Two small bulges facing each other
-A bank slightly higher than the fins on the back ... In the photo, the high part is printed with red filament to further clarify the difference between the front and back.
-[print conditions]
-printing type: FDM
-printer: Original Prusa i3 MKS
-filament: PETG
-support: no
-brim: no
-raft: doesn't matter
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
