Thingiverse
pet bowl
door jim0089
3
Downloads
6
Likes
0
Makes
The original plate is always overturned by it, or some cat food will be pushed to the side by it, and it is difficult to find it. If you keep adding it, it may break after a long time. Therefore, I designed this food plate and have been using it for a period of time. , the effect is very good, no cat food is spilled next to it, and it has not been turned over once.
On the front of the model, the inner edges are curved, and the food will not stay around, but will always be in the center.
The bottom is hollowed out to save material. No support is needed when printing. Just adjust the proportions and print directly. The design size is an overall diameter of 25cm. You can adjust the size according to your own cat, dog and printer.
Use black PLA to print, adjust the ratio to 80%, print out a diameter of 20cm, take 4.5 hours, use 130g of consumables, and cost about 7 yuan.
原来的盘子总是被它掀翻，或者有些猫粮会被它拱到边上，吃不找，不断添加，时间久了，可能会坏掉，所以，设计了这个食盘，目前使用一段时间，效果非常好，旁边再没有撒出猫粮，也没有被翻过一次。
模型正面，内部边缘是曲
On the front of the model, the inner edges are curved, and the food will not stay around, but will always be in the center.
The bottom is hollowed out to save material. No support is needed when printing. Just adjust the proportions and print directly. The design size is an overall diameter of 25cm. You can adjust the size according to your own cat, dog and printer.
Use black PLA to print, adjust the ratio to 80%, print out a diameter of 20cm, take 4.5 hours, use 130g of consumables, and cost about 7 yuan.
原来的盘子总是被它掀翻，或者有些猫粮会被它拱到边上，吃不找，不断添加，时间久了，可能会坏掉，所以，设计了这个食盘，目前使用一段时间，效果非常好，旁边再没有撒出猫粮，也没有被翻过一次。
模型正面，内部边缘是曲
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
